Non-Destructive Test Technician 3/4
Northrop Grumman
- Iuka, MS
- Permanent
- Full-time
- Review routers, procedures, specifications, and other instructions for completeness and instructions to perform operation
- Process parts in accordance with procedures and technical instructions to evaluate for weld, braze, and/or casting discontinuities exceeding specified requirements
- Work with UT and X-ray generating equipment
- Set-up, operate, calibrate, and perform Process Control Checks on NDT equipment by following established instructions and record results
- Interpret, evaluate, and report evaluation results, as required and outlined
- Fill out required logs and statistical data sheets, as required
- Maintain required job skills and knowledge of requirements (including procedures, specifications, etc.)
- Maintain work area, equipment, and all documents/records to be audit ready at all times
- Provide On-the-Job Training (OJT) to Level I NDT Inspectors and fellow Level II NDT Inspectors
- Assist the Level III in developing specific test techniques
- Completes these and other job duties as instructed
- High School diploma or equivalent and 4 years additional education and/or manufacturing experience in nondestructive testing experience.
- Currently or previously certified to NDT Level II in UT and X-ray in accordance with NAS-410 (documentation required)
- Ability to provide documentation showing the completion of radiation safety training in accordance with state laws.
- Able to read and interpret blueprint and engineering drawings and be able to document non-conformances as required
- Ability to successfully pass vision screen and color blindness tests
- Ability to pass General, Specific, and practical exams within a reasonable amount of time as determined by the company .
- Able to be subject to a variety of physical conditions and areas which could cause various phobias due to height or closed spaces
- Able to lift up to approximately 25 pounds. May occasionally lift 50 pounds (with assistance)
- Ability to obtain and maintain a DoD Secret Clearance and special program access
- High School diploma or equivalent and 6 years additional education and/or manufacturing experience in nondestructive testing experience.
- Currently or previously certified to NDT Level II in UT and X-ray in accordance with NAS-410 (documentation required)
- Ability to provide documentation showing the completion of radiation safety training in accordance with state laws.
- Able to read and interpret blueprint and engineering drawings and be able to document non-conformances as required
- Ability to successfully pass vision screen and color blindness tests
- Ability to pass General, Specific, and practical exams within a reasonable amount of time as determined by the company .
- Ability to obtain and maintain a DoD Secret Clearance and special program access
- Aerospace or aviation experience
- Able to utilize measuring devices including comparators, micrometers, scales, and calipers
- Experience with X-ray film and non-film methods
- Familiarity with AS9100, NADCAP, and other Quality / NDT auditing / accreditation systems strongly preferred
- Experience with digital/computed radiography (CR) strongly desired (familiarity with GE CR systems and software a plus)
- Experience with Automated Through Transmission Systems strongly desired.
- Experience with MAUS systems strongly desired.
- Experience with Multiple brands of Flaw detectors strongly desired.
- Experience in the interpretation of flaws in Composites desired
- Certification in other NDT methods (Flash thermography) strongly desired
- Positive attitude and ambition to excel / advance in skills and knowledge
- Attention to detail and an ability to produce error-free products and accurately complete paperwork
- Willingness to cross train in other NDT methods
- Ability to work extended or flexible schedule on short notice as needed.
- Able to work under general direction with minimal supervision