Assembly Technician
Boeing
- Auburn, WA
- $20.00-43.74 per hour
- Permanent
- Full-time
- Employees in this position work in a cell environment with various aircraft parts
- Performing installation and assembly of various details and assemblies (e.g., brackets, sensors, grease fittings, bushings) per drawing specifications
- Employment in this position also requires bending and twisting at the waist, lifting/carrying, pushing/pulling, use of low and high impact vibratory tools, walking, standing, finger manipulation, contact with metals, exposure to noise and atmospheric conditions, and the use of personal safety gear for face/eye, hand/arm, ears and feet
- Obtain work assignments from bar chart, (WO) Work Order, supervisor or other accepted shop procedures
- Schedule and priority determine work sequence
- Use personal computer to obtain information (e.g., drawings, specifications, (DCAC) Design Configuration and Control), as required
- Work with expediters and shop clerks to maintain inventory of perishable items in shop supply storage area, as required
- Ensure proper tooling is in inventory to complete scheduled work assignments, as required
- Perform routine maintenance on hand and power tools (e.g., lubrication, visible defects, certification in date), as required
- Select proper tooling (e.g., holding fixtures, drill motors, reamers) to perform work (e.g., spot facing, swedging, deburring) on parts/assemblies, as required
- Use mathematical formulas to verify locations of holes to ensure work is within specifications, as required
- Prepare edges and blend surfaces as required for shotpeen as well as shotpeen / rotopeen parts
- Perform drilling/reaming operations using power tools (e.g., drill motors, Quackenbush tool, cleco motors), mounted on tabletops, as required
- Perform assembly of various parts using hand tools (e.g., wrenches, sockets, hammers, drifts), as required
- Perform cold work process on holes
- Shrink fit and install bushings using (LN2) Liquid Nitrogen per BAC specifications
- Perform certification work (e.g., surface/fay seal (e.g., BMS 5-95), prepack, fillet), on bushings/bearings and other part installations per specification requirements
- Touch up surface defects on parts using Alodine and Primer to prevent corrosion to meet drawing requirements, as required
- Perform honing/reaming operations on various metals (e.g., Aluminum, Beryllium/Cobalt, Stainless Steel), as required
- Use (PME) Precision Measuring Equipment (e.g., dial bore gauge, micrometer, profilometer) to ensure parts/assemblies are within specification
- Ensure fastener is torqued to proper specification using calibrated torque wrench, as required
- Ensure parts are grounded together properly by performing bonding checks on completed assemblies with Biddle meter, as required
- Work with QA to write rejection tags on failed vendor parts and other discrepancies found during assembly, as required
- Move parts into and out of area using overhead crane, as required
- Handle and dispose of hazardous material in approved manner per (MSDS) Material Specification Data Sheets, as required
- Wear (PPE) Personal Protective Equipment in shop area, as required
- Maintain personal certifications (e.g., bond and ground, eye, shotpeen, crane handling, fay/seal), as required.
- English -
- Spanish -
- English -
- Spanish -