Joiner/Carpenter/Fabricator - Riviera Prenail (Silverdale, Auckland)
Mitre 10
- New Zealand
- $25.00-32.00 per hour
- Permanent
- Full-time
- You would have experience and an understanding of how to operate within the regulatory environment as it applies to frame and truss
- You would have knowledge of NZS 3604: 2011 and an understanding of general construction methodology
- You would be able to determine timber requirements and apply knowledge of floor, wall and roof construction
- You would have knowledge of timber grades.
- You would have the ability to read technical documents and drawings
- You would have an excellent understanding of carpentry techniques and methods of installation and construction including hands-on experience working with carpentry materials
- You would be a competent user of nail guns and drop saws and other related tools
- You would have good numeracy skills as it is applied to measuring, cutting and assembling timber.
- You would need to have a minimum of 2 years construction or joinery or carpentry related work experience
- You would ideally have a National Certificate in Frame and Truss Manufacturing OR a National Certificate in Carpentry at NZQF level 3/4 (ANZSCO Skill Level 3). This would be beneficial but not a pre-requisite if you have the required experience mentioned above.
- Pre-cutting framing components, materials and wood joints - cutting of components to be included in the framing e.g.: studs, nogs, lintels etc.
- Cutting of soffit bearer and other items to go with completed framing
- Trenching of framing top and bottom plates
- Assembling and nailing together the cut and shaped parts / framing components in a precise and efficient manner using either handheld nail guns, mechanic nailing machines or a hammer.
- Pre-cutting truss components - cutting of truss cords, webs, sundries and rafters using either the manual system or the computer-controlled automated system.
- Truss fabrication - set up and pressing of Main and Jack trusses using either the rail jig system (hydraulic or pneumatic press) or the roller press system.
- Posi - Strut Fabrication - set up and pressing of posi-struts, using the posi-strut jigs and the pneumatic press
- Beam Fabrication - set up and pressing or nailing of specially designed beams (Ganglam, Maxspan & Flitch) using either the hydraulic press or the Hilti gun depending on the beam.